Hi,
I have set upi the diyhue bridge and installed the esp8266 correctly. I can see the esp in the diyhue controller. I have wired the controller up just like it is shown in the instructions
Red to VIN 5v
White to Ground
Green to RX
I have added a external power supply to the extra red and white cable on my Wd2812b
WHen I put power to the strip, nothing happens. I have configured my zone with a total of 72 leds. I haave not connected the USB power and injector on at the same time. I´v heard that should not be done.
The strip doesn´t turn on.I´v tried with 2 different strips but it does help.
looks good.
you used the WS2812_STRIP v3.1?
does the strip flash when you power the esp? White = booted, green = WLAN connected, red = WLAN could not connect
have you setup the leds in the webui of the esp in the tab preferences?
can you control the strip via the webui of the esp?
you can find the ip of the esp on the webui of diyhue under lights.
if this works and not via the hue app i need to see the logs the best thing is to share the full debug from webui>diyhue>bridge>bridge control>download debug>full debug.
